Quick Set Tree Set Up
Updated
Quick set trees are the quickest and easiest Christmas tree to assemble. Quick set trees are a new technology introduced Christmas 2012.
Step 1
Remove parts from the box. Reference the user manual to ensure that all required parts are accounted for. If you are missing parts, contact Polygroup customer service at 1-888-919-0070.
Step 2
Assemble stand on a level surface near a wall outlet, allowing for space by measuring diameter listed on box.
Metal Wire Stand:Assemble by pulling into an “X” shape with 90-degree angles.
Sheet Metal Stand:Unfold the legs and lay the stand flat, then slide the locking disc downward and snap into place. Some metal stands also require a slight turn to lock the disc.
Plastic Stand: Insert plastic legs into the grooves in the stand center. Make sure the stand is stable after the legs are installed.
Rotating Stand: Follow the below instructions.
Step 3
Remove the protective caps from the tree bottom section. Insert the pole into the tree stand. Continue removing caps and fitting the next section into the first until all sections are assembled. Shape the branches working from the bottom up. For more information on shaping/fluffing the tree, please seeFluffing-and-Shaping your tree. Ensure all wires are free of hinges.
Step 4
Insert the green label extension cord plug into the wall outlet. All your lights should be illuminated. If the lights aren't working, please refer to the troubleshooting tips on tree lights.
Quick Set Tree Setup Diagram:
Quickset, 2020 version:
TWO contact points in the center with 2 openings on the female side.
The section connector white plastic is Perfectly Round.
There are 4 round shaped holes on the Male pin side of the connector.
There is a Silver button bump out pin on one side of the pole.
There are White arrows on the pole connections to line up the sections correctly (See images below)
Assembly Manual example page for Quickset 20 -
This graphic shows the alignment arrows on the side of the poles.
Quickset, 2019 version:
TWO contact points in the center with either 2 or 4 openings on the female side.
The section connector white plastic has a FLAT edge on one side.
There are two side fins on the inner edges of female connection.
There are multiple square shaped holes on the Male pin side of the connector.
There is a Silver button bump out pin on one side of the pole.
Quickset, 2014-2018 versions:
One single contact point in the center with one single opening on the Female side. The section connector white plastic is perfectly round.
Quickset, 2018 version (LED):
One single contact point in the center with one single opening on the Female side.
The section connector is Green plastic and is perfectly round.
For the 1.25” LED the center is jack style - For the 2” LED the center connection looks like the 18 above but is Green.
Quickset, 2013 version:
In 2013 the Quicksets were made with Two prongs.
These Quicksets had the prongs offset to one side.
This style of Quickset is no longer being manufactured; and is not compatible with current Quicksets.
