Pro Series Rectangular Frame Pool
Updated
Locate a flat, level area to set up the pool. Make sure the ground is free from sharp objects that may puncture the pool.
Carry the pool liner to the desired location. DO NOT drag the liner on the ground to the location.
Locate the pool so that the pump opening is 10 to 21 feet away from an electrical outlet.
Connect the long Horizontal Beams; there should be two two sets of these.
Example: If there are 6 long vertical beams, each row of connected beams will be 3 long beams.
Carefully slide the connected horizontal beam's swedged end into the sleeves on the long sides of the pool liner.
Connect the short horizontal beams, there are also two sets of these.
Example:If a customer has 4 short vertical beams, each row of connected beams will be 2 beams long.
Carefully slide the connected short horizontal beam's swedged end into the sleeves on the short sides of the pool. All swedged ends should now be pointing in a clockwise direction after they are inserted.
Align the holes of all horizontal beams with the sleeve openings. This allows you to connect the U-shaped beams later.
Attach the corner pieces to the horizontal beams with the swedged ends still pointing clockwise. The corner pieces DO NOT have a hole to catch the spring pin. Only the horizontal beams have holes to catch the spring pins.
Slide the U-beams into the designated flaps at the bottom of the pool liner. Once this is completed, all U-shaped beams should be lying flat on the ground surrounding the pool. Please see images below.
Tilt the prongs of the U-beams up toward the horizontal beams, pinch the spring button and push into the corresponding holes on the horizontal beams. Repeat this step for all U-beams.
Make sure the drain fitting is securely plugged and the cap is in place.
Start filling the pool with water until 1 inch of water is on the bottom. Pause filling and smooth the wrinkles out on the bottom of the pool by pushing outward from the inside of the pool. When you are finished, the pool should lie even and flat. If more than 1-2 inches of water collects on any one side before the pool starts filling in the center, the pool is not level enough and must be moved to a level area.
Install the filter pump; see this schematic to aid in the SFS Filtration System installation or the SFX schematics. Once the filter pump is installed, continue filling water into the pool. When the water is half filled, the top frame will tend to bend down at the middle. THIS IS NORMAL. Continue to fill water to the optimal level as indicated on the face plate of the filter system and the frame will restore its shape.
