Draining the Pool

Updated

Locate the drain plug on the outside pool wall and remove the drain cap. A standard garden hose will thread onto the drain fitting. Extend the hose to the area where the water is to be drained. Open the drain plug on the inside wall of the pool and water will drain out through the hose. If you can't find the drain plug on the inside, the ”useful tips” section below for troubleshooting.
Remove any remaining water. Wash and completely dry the pool using a soft cotton cloth. Push the drain plug into the fitting and replace the cap.

Frame Pools: If your pool has a metal framework, disassemble those pieces. This is done depending on the model of the pool. You either depress the plastic buttons and slide those pieces apart, or remove the plastic pins holding the pieces together and slide those pieces apart. If you aren't sure how to take down the pool, refer to the set-up sheet and reverse the order of the steps.
Clean all parts and wipe dry. Store together in a safe storage place for reassembly next season. Order replacement parts for any damaged, broken, or worn parts from Polygroup customer service at 1-888-919-0070 or at our online store. It is best to order parts now so you will have them ready for when you set up the pool next season.
Solar blankets, covers, ladders, etc., should be cleaned and dried before storing.

The drain to the pool will be found a few inches from the ground on the left or right side of the filter canister. If you can not find the drain cap, it likely means the liner floor was not spread evenly, and the cap is under the lip of the pool. Run your hand under the floor of the pool on both sides of the canister. Once the cap is found, expose it by pushing up on the pool enough to unscrew the cap. This likely require the use of a secondary method of removing water from the pool, such as an independent water pump.
There are slight differences in garden hose nozzle threads. This can cause some hoses not to screw properly onto the drain cap threading. Basic hoses have a higher probability of fitting the thread.

If you have any questions, please contact us at 1-888-919-0070. You can also contact us at warranty@polygroup.com