Frame Disassembly
Updated
Frame dis-assembly
Below are tips that can make the process easier.
Pin and grommet removal
A small rubber mallet can be used to tap the ends of the pins through the bottom of the horizontal beams along the top of the frame.
Alternately, a pair of needle nose pliers can be utilized to remove the pins. Using the needle nose pliers, compress the ends of pin together and push up. The compression of the end allows the exposes flanges that lock under the lip of the hole to slip inside the horizontal beam. Slip the needle nose pliers underneath the head of the pin and pull up, the pin can then be removed from the horizontal beam.
If you break pins during this process, you may purchase replacements by contacting Polygroup customer service at 1-1-888-919-0070 or at our online store.
Dismantling frame after pin removal
Tip: There are many reasons why, at the end of the season why frame components will not come apart. In the extreme heat of summer, metal expands, which makes it difficult if not impossible, to take frame apart. It is suggested to wait until the temperature drops giving time for the metal to cool and the metal to ”Shrink” back to its normal dimensions.
There is also a phenomenon known as hydrolysis, where the salty air and water creates a situation where the frame components all but weld together.
What is suggested if you live in a high humidity area with salty air or if you are using a salt water filter, is to use a WD40 pretreatment or other silicone spray on all joints before putting the frame together. You can also use the WD-40 at the end of the season to break apart the joints. Be certain to wipe away any excess before putting the frame together. Clean off all spray before storing the frame for the off-season.
Metal expands in heat. Allow the pool frame to cool into the early evening before continuing dis-assembly.
Use two people to make the process easier. The horizontal beam is pulled away from the T-fitting by one person.
The second person pulls the T-fitting the opposite direction, lifting up on both in a ”opening a draw bridge” like motion to release the tension of the frame.
Rotate frame pieces clockwise, then counter clockwise. Repeat to aid in separating frame components. Utilizing two people makes the process much easier.
Leg caps can be difficult to remove. This is due to the extreme weight of the pool with water pressing down on them. Tap the bottom and sides of leg caps with a rubber mallet to loosen dirt and grim. Rotate the cap back and forth, clockwise and counter clockwise to loosen. Having a second person hold the vertical leg may be helpful.
If you have any questions, please contact us at 1-888-919-0070. You can also contact us at warranty@polygroup.com
