Pool Storage & Winterizing

1. Check local regulations for specific directions regarding disposal of swimming pool water.

   ​

2. Drain your pool. See the article Draining the Pool for detailed instructions.

   ​

3. Replace the drain cap on the outside of the pool.

   ​

4. Completely deflate the top ring and remove all connecting parts.

   ​

5. Be sure that the pool and all parts are completely dry before storage. Air dry the liner in the sun until completely dry before folding. Sprinkle some talcum powder to prevent the vinyl from sticking together and to absorb any residual moisture.

   ​

6. Create a square shape. Starting at one side, fold one-sixth of the liner into itself twice. Do the same on the opposite side.

   ​

7. Once you have created two opposing folded sides, simply fold one over the other like closing a book.

   ​

8. Fold the two long ends to the middle.

   ​

9. Fold one over the other like closing a book, and finally compact the liner.

   ​

10. Store the liner and accessories in a dry, temperature controlled storage location, between 32 degrees Fahrenheit (0 degrees Celsius) and 104 degrees Fahrenheit (40 degrees Celsius).

    ​

11. The original packing can be used for storage.

    ​

Winterizing Your Above Ground Pool

After usage, you can easily empty and store away your pool in a safe place. Some pool owners, however, choose to leave their pool up all year round. In cold areas, where freezing temperatures occur, there can be a risk of ice damage to your pool. We therefore recommend you drain, disassemble, and properly store the pool, when the temperature drops below 32 degrees Fahrenheit (0 degrees Celsius). Clean the pool water thoroughly, please see How to Clean a Polygroup Liner for more detailed information.

​

1. Clean the pool water thoroughly. If the type is a Quick Set Pool, make sure that the top ring is properly inflated.

   ​

2. Remove the skimmer (if applicable) or any accessories attached to the threaded strainer connector. Replace strainer grid if necessary. Be sure all accessories parts are clean and completely dry before storage.

   ​

3. Plug the Inlet and Outlet fitting from the inside of the pool with the plug provided (sizes 16' and below). Close the Inlet and Outlet Plunger Valve (sizes 17' and above).

   ​

4. Remove the ladder (if applicable) and store in a safe place. Be sure the ladder is completely dry before storage.

   ​

5. Remove the hoses that connect the pump and filter to the pool.

   ​

6. Add the appropriate chemicals for the winter period. Consult your local pool dealer as to which chemicals you should use and how to use them. This can vary greatly by region.

   ​

7. Cover pool with Polygroup™ Pool Cover.

   IMPORTANT NOTE: Polygroup™ POOL COVER IS NOT A SAFETY COVER.

   ​

8. Clean and drain the pump, filter housing, and hoses. Remove and discard the old filter cartridge. Keep a spare cartridge for the next season.

   ​

9. Bring pump and filter parts indoors and store in a safe and dry area, preferably between 32 degrees Fahrenheit (0 degrees Celsius) and 104 degrees Fahrenheit (40 degrees Celsius).